COLREG Rules 5–8
Rules 5–8 form the core of collision avoidance.
Before and while applying the specific stand-on and give-way rules, you still need to detect what is happening, proceed at a safe speed, assess whether risk of collision exists and take effective action.
A useful way to remember the sequence is:
LOOK OUT → CONTROL SPEED → ASSESS RISK → ACT & CHECK
These rules apply in any condition of visibility.
Rule 5 — Look-out
Rule 5 requires every vessel to maintain a proper look-out at all times.
That means more than occasionally looking around.
A proper look-out uses:
- sight
- hearing
- all other available means appropriate to the circumstances
Depending on your vessel and equipment, those other means might include radar, AIS and information received by VHF.
The purpose is to build a full picture of what is happening around you and identify whether there is a risk of collision.
What does a proper look-out mean in practice?
On a sailing yacht, it means actively monitoring the whole situation around the boat rather than concentrating only on what is directly ahead.
You should be asking:
- What vessels are around us?
- Where are they relative to us?
- Are their bearings changing?
- How quickly are we closing?
- Is anything difficult to see because of weather, sea state, darkness or background lights?
- Could another vessel or hazard be hidden by the sails, spray or part of the boat?
A proper look-out is continuous.
Seeing another vessel once is not enough. You need to keep monitoring it so you can understand how the situation is developing.
Rule 6 — Safe speed
Rule 6 requires every vessel to proceed at a safe speed.
There is no single speed in knots that is always “safe”.
A safe speed is one that allows you to:
take proper and effective action to avoid collision and stop within a distance appropriate to the circumstances and conditions.
When deciding what speed is safe, consider factors including:
- visibility
- traffic density
- your vessel’s manoeuvrability
- stopping distance and turning ability
- background lighting at night
- wind, sea state and current
- nearby navigational hazards
- your draught in relation to the available depth
If radar is fitted and being used, its capabilities and limitations also need to be considered.
Safe speed changes with the situation
A speed that is perfectly reasonable offshore in clear visibility may be unsafe in fog, at night in crowded water or when manoeuvring through a busy harbour.
Safe speed is therefore not about sailing slowly all the time.
It is about travelling at a speed that gives you enough time and space to understand what is happening and take effective action.
Rule 7 — Risk of collision
Once another vessel has been detected, Rule 7 requires you to use all available means appropriate to the circumstances to determine whether a risk of collision exists.
If there is any doubt, risk of collision should be assumed to exist.
One of the most useful visual indicators is the relative bearing of the other vessel.
If the bearing remains nearly constant while the distance between the vessels decreases, there is a risk of collision.
This is often remembered as:
Constant bearing + decreasing range = collision risk.
But do not rely on that test alone.
A noticeable bearing change does not automatically mean that there is no risk, particularly when approaching:
- a very large vessel
- a tow
- another vessel at close range
Radar, where fitted and operational, should be used properly to help assess risk of collision. AIS can provide useful supporting information about other vessels, but should not be relied upon as the primary means of determining collision risk.
You should not make assumptions based on limited information.
What is CPA?
CPA means Closest Point of Approach.
It describes the closest distance at which another vessel is expected to pass if both vessels maintain their present course and speed.
A small CPA can indicate that a close-quarters situation is developing.
But CPA should be used as part of the overall assessment, not treated as a single number that replaces judgement.
Rule 8 — Action to avoid collision
If action is required to avoid collision, Rule 8 says that it should be taken in accordance with the Rules and, when circumstances allow, it should be:
positive, made in ample time and with due regard to good seamanship.
Small alterations made too late can make your intentions difficult for another vessel to understand.
A sufficiently large alteration of course, when appropriate, can be easier for another vessel to detect.
Whatever action you take should result in passing at a safe distance.
Act — then check
Avoiding action is not finished simply because you have altered course or speed.
You must continue monitoring the other vessel.
The action should be checked until the vessel is finally past and clear.
If necessary, you may need to:
- alter course
- reduce speed
- stop
- reverse your means of propulsion
The appropriate action depends on the situation and on the other COLREG rules that apply.
How Rules 5–8 work together
These rules are best understood as one continuous process.
1. LOOK OUT
Detect vessels and hazards early.
Use sight, hearing and all other appropriate available means.
2. CONTROL SPEED
Travel at a speed that gives you enough time and distance to respond effectively.
3. ASSESS RISK
Monitor the other vessel.
Consider its bearing, range and movement.
If you are in doubt about whether a risk of collision exists, assume that it does.
4. ACT & CHECK
Take clear and effective action in good time.
Then continue monitoring the situation until the vessels are finally past and clear.
Example: another vessel ahead
Imagine you are sailing and spot another vessel several miles away.
A single glance does not tell you whether you will collide.
First, maintain a proper look-out and continue observing the vessel.
Then consider your own speed and whether it is appropriate for the conditions.
Take repeated bearings or use other available information to determine whether the vessels are converging.
If the bearing remains nearly constant while the range decreases, you should treat the situation as a collision risk.
You can then determine which additional COLREG rules apply and, where required, take clear action in plenty of time.
After taking action, continue monitoring the vessel until it has passed safely clear.
That entire process continues while you apply the specific stand-on and give-way rules that may also govern the encounter.
Common mistakes
“I saw the other boat, so I was keeping a proper look-out.”
Not necessarily.
A proper look-out means continuously building and updating your understanding of the situation.
“We were below the speed limit, so our speed was safe.”
Not necessarily.
COLREG safe speed depends on the circumstances and conditions, not simply a local numerical speed limit.
“The bearing changed slightly, so there is no collision risk.”
Not necessarily.
Rule 7 requires you to use all appropriate available information and warns against making assumptions from limited information.
“I altered course, so the collision-avoidance action is complete.”
No.
Continue monitoring until the other vessel is finally past and clear.
Remember
When approaching any developing traffic situation:
- LOOK OUT
- What is around me?
- CONTROL SPEED
- Can I respond effectively?
- ASSESS RISK
- Are we converging?
- ACT & CHECK
- Take clear action and make sure it worked.
These four rules create the foundation for the more specific steering and sailing rules that follow.
Continue learning
- COLREGs overview
- See how the main COLREG topics fit together.
- Restricted Visibility — Rule 19
- Understand how collision avoidance changes when vessels are not in sight of one another.
- Navigation Lights
- Learn how to recognise vessels and their activity at night.
- Sound Signals
- Understand manoeuvring, warning and restricted-visibility signals.
Practise in StandOn
StandOn helps you practise collision-avoidance knowledge through repeated recall rather than simply rereading the rules.
Practice. Recall. Repeat.
Sources and review
This resource is written as a learner-friendly explanation of COLREG Rules 5–8.
Primary sources include:
StandOn provides learning guidance rather than reproducing the full Regulations. Where exact wording matters, refer to the current official COLREG text.
StandOn is an independent learning platform and is not affiliated with or endorsed by the RYA, IMO or MCA.
