COLREG Rule 10 — Traffic Separation Schemes

Rule 10 sets out how vessels should navigate in and around Traffic Separation Schemes, or TSSs.

Traffic Separation Schemes organise vessel traffic into defined lanes, usually in busy or constrained areas.

They help reduce conflicting traffic movements, but they do not replace the rest of the COLREGs.

A useful way to think about Rule 10 is:

USE THE RIGHT LANE → CROSS CLEARLY → KEEP OUT OF SEPARATION AREAS → DO NOT IMPEDE

What is a Traffic Separation Scheme?

A Traffic Separation Scheme separates vessels travelling in different directions into defined traffic lanes.

A typical scheme may include:

  • traffic lanes
  • separation lines or separation zones
  • inshore traffic zones
  • termination areas
  • associated routeing measures

Rule 10 applies to Traffic Separation Schemes adopted by the International Maritime Organization.

If you are navigating in or near one, you must still comply with the other COLREG rules that apply.

A vessel travelling in a traffic lane does not automatically have priority over every vessel crossing the lane.

Using a traffic lane

If you are using a traffic lane, you should:

  • proceed in the appropriate lane
  • travel in the general direction of traffic flow
  • keep clear of the separation line or separation zone so far as practicable

You should normally join or leave a traffic lane at the end of the lane.

If you need to join or leave from the side, do so at as small an angle to the general direction of traffic flow as practicable.

The aim is to make your movement predictable to other vessels using the scheme.

Crossing a Traffic Separation Scheme

Rule 10 says that, so far as practicable, you should avoid crossing traffic lanes.

But sometimes crossing is necessary.

When crossing a traffic lane, you should cross:

on a heading as nearly as practicable at right angles to the general direction of traffic flow.

The word heading matters.

It does not say that your course over the ground must be exactly 90° to the traffic lane.

Heading is not the same as course over ground

Imagine the traffic lane runs east–west and you need to cross from south to north.

If there were no tide, you might steer north and your track over the ground would also be north.

But with a strong tidal stream pushing you sideways, your track across the chart may be diagonal.

That does not necessarily mean you are breaking Rule 10.

The requirement is for your heading to be as nearly as practicable at right angles to the general direction of traffic flow.

So you should not automatically alter your heading to compensate for tide simply to make your ground track appear perpendicular to the lane.

The purpose is to make your intentions clearer to vessels following the lane.

Do I need to cross as quickly as possible?

The goal is not simply to produce the shortest possible track across the lane.

The MCA specifically distinguishes heading from course over ground.

A right-angle heading creates a clearer encounter for vessels following the traffic lane, even where tidal stream causes your actual track over the ground to be angled.

If you are genuinely crossing the lane, the crossing should normally be completed in one continuous movement.

If you intend to stop crossing and instead proceed along the lane, you are no longer simply crossing it — you are effectively joining the traffic lane and the rules for using that lane apply.

Does traffic in the lane have right of way?

No.

Rule 10 does not give a vessel following a traffic lane automatic priority over every other vessel.

The other Steering and Sailing Rules continue to apply.

For example, where two power-driven vessels are in sight of one another and a risk of collision exists, the normal crossing, overtaking or head-on rules may still determine which vessel should take avoiding action.

That means you should not think:

“They are in the TSS, so I must always give way.”

But there is an important additional obligation for small craft and sailing vessels.

Small vessels and sailing vessels

A vessel of less than 20 metres in length, or a sailing vessel, must not impede the safe passage of a power-driven vessel following a traffic lane.

For a typical cruising yacht, that is one of the most important parts of Rule 10.

In practical terms, plan your crossing early and avoid creating a situation where a large vessel following the lane has to alter course or speed because of you.

This obligation does not disappear if a risk of collision develops. The other Steering and Sailing Rules still apply, but a vessel that is required not to impede must continue to take that obligation into account.

In UK guidance, “impeding” is interpreted as causing the vessel whose safe passage should not be impeded to be forced to alter course or speed.

Sailing with the engine running

Remember that a yacht using its engine is a power-driven vessel for the purposes of the COLREGs.

If light or adverse winds make it difficult to comply with the routeing measures under sail, MCA guidance says the vessel should use its engine and comply as a power-driven vessel.

That means displaying the appropriate lights, shapes and signals required for a power-driven vessel.

What does “do not impede” mean?

For a small vessel or sailing vessel, “do not impede” means you should take early action so that a power-driven vessel following the lane can continue its safe passage.

Do not deliberately create a close-quarters situation and rely on becoming the stand-on vessel later.

Think ahead.

If your planned crossing would force traffic in the lane to alter course or speed significantly, wait for a better opportunity or adjust your plan early.

Inshore Traffic Zones

An Inshore Traffic Zone, or ITZ, lies between the landward boundary of a TSS and the coast.

A vessel should not normally use an ITZ if it can safely use the appropriate traffic lane.

However, Rule 10 specifically allows:

  • vessels under 20 metres
  • sailing vessels
  • vessels engaged in fishing

to use an Inshore Traffic Zone.

Other vessels may also use one when travelling to or from a port, offshore installation, pilot station or another place situated within the zone, or when avoiding immediate danger.

Do not assume an ITZ is one-way traffic

Traffic inside an Inshore Traffic Zone may be travelling in different directions.

It should not be treated like another TSS traffic lane.

Continue to maintain a proper look-out and apply the normal collision-avoidance rules.

Separation zones and separation lines

Unless you are crossing, joining or leaving a traffic lane, you should not normally enter a separation zone or cross a separation line.

Exceptions include:

  • an emergency where necessary to avoid immediate danger
  • fishing within a separation zone

For normal passage planning, treat the separation zone as an area to keep clear of rather than somewhere to cut through.

Anchoring in or near a TSS

So far as practicable, avoid anchoring within a Traffic Separation Scheme or near its terminations.

Safety comes first.

If anchoring is necessary to protect the vessel — for example because of propulsion or steering failure — MCA guidance recognises that anchoring within an Inshore Traffic Zone or separation zone may be necessary.

If you are not using the scheme

If you are not using a Traffic Separation Scheme, you should avoid it by as wide a margin as practicable.

That helps prevent your navigation from interfering with vessels using the scheme.

Be particularly careful at the ends of a TSS

Traffic movements can become less predictable near the termination of a Traffic Separation Scheme.

Vessels may be:

  • joining a lane
  • leaving a lane
  • crossing
  • altering course towards their next route

Rule 10 therefore requires vessels navigating near the termination of a TSS to do so with particular caution.

Fishing vessels

A vessel engaged in fishing must not impede the passage of any vessel following a traffic lane.

Fishing within a TSS is not automatically prohibited, but the vessel must still comply with the relevant requirements of Rule 10 and the other COLREGs.

A practical crossing example

Imagine you are sailing north and need to cross an east–west traffic lane.

Large commercial vessels are travelling east through the lane.

Before crossing:

  1. Maintain a proper look-out.
  2. Assess the traffic pattern, bearings and collision risk.
  3. Decide whether there is sufficient space to cross without impeding vessels following the lane.
  4. Plan to cross on a heading as nearly as practicable at right angles to the traffic flow.
  5. Allow for the tidal stream when predicting where you will end up, but do not confuse your ground track with the heading required by Rule 10.
  6. Continue monitoring traffic throughout the crossing.
  7. Apply the other COLREG rules if a risk of collision develops.

The objective is a crossing that is clear, predictable and made without impeding traffic following the lane.

Common mistakes

“My chart track has to cross the TSS at exactly 90°.”

No.

Rule 10 refers to your heading, not your course over the ground.

Tide may make your actual track across the scheme appear diagonal.

“Ships in the traffic lane always have right of way.”

No.

The other COLREG rules still apply.

However, a sailing vessel or vessel under 20 metres must not impede the safe passage of a power-driven vessel following a traffic lane.

“I’m sailing, so I can use whichever part of the TSS I want.”

No.

Being a sailing vessel gives you permission to use an Inshore Traffic Zone, but it does not remove your other Rule 10 obligations.

“The Inshore Traffic Zone is just a lane for small boats.”

No.

Traffic may travel in either direction, and other vessels may legitimately use the zone in circumstances permitted by Rule 10.

“I can avoid a ship by stopping halfway across the lane.”

Do not plan a crossing that way.

If you intend to stop crossing and proceed within the lane, the MCA treats that as joining the lane rather than simply crossing it.

Remember

When navigating around a Traffic Separation Scheme:

USE THE RIGHT LANE
Follow the general direction of traffic.
CROSS CLEARLY
If crossing is necessary, use a heading as nearly as practicable at right angles to the traffic flow.
KEEP OUT OF SEPARATION AREAS
Do not normally use the separation line or zone.
DO NOT IMPEDE
If you are under 20 metres or sailing, do not impede the safe passage of a power-driven vessel following the lane.

And throughout the encounter:

Rules 5–8 still apply.

Keep a proper look-out, proceed at a safe speed, assess collision risk and take effective action when required.

Continue learning

COLREGs overview
See how the main COLREG topics fit together.
COLREG Rules 5–8
Learn the continuous process of look-out, safe speed, collision-risk assessment and avoiding action.
Restricted Visibility — Rule 19
Understand how collision avoidance works when vessels are not in sight of one another.
Navigation Lights
Recognise vessels and their activity at night.

Practise in StandOn

StandOn helps you build COLREG knowledge through repeated practice and recall.

Practice. Recall. Repeat.

Sources and review

This resource is a learner-friendly explanation of COLREG Rule 10.

Primary sources include:

StandOn provides learning guidance rather than reproducing the full Regulations. Where exact wording matters, refer to the current official COLREG text and relevant charted or local navigation information.

StandOn is an independent learning platform and is not affiliated with or endorsed by the RYA, IMO or MCA.